IHaunch Properties

The IHaunch type exposes the following members.

Properties
 NameDescription
Public propertyBuiltUpPlateFlangeThickness Gets the built-up plate flange thickness
Public propertyBuiltUpPlateFlangeWidth Gets the built-up plate flange width
Public propertyBuiltUpPlateWebThickness Gets the built-up plate web thickness
Public propertyCutSection Gets the cut section
Public propertyCutType Gets the type of the haunch cut
Public propertyCutWidth Gets the width of the haunch cut (in [mm])
Public propertyDepth Gets the depth, Dh (in [mm])
Public propertyDepthOption Gets the haunch depth option
Public propertyEndPlate Gets the end plate
Public propertyFabrication Gets the fabrication
Public propertyFlangePosition Gets the flange position the haunch is attached to
Public propertyGamma Gets the value of Gamma (in [rad])
Public propertyLength Gets the length, Lh (in [mm])
Public propertyMaxCutDepth Gets the maximum cut depth (in [mm])
Public propertyMaxCutDepthKnown Gets a value indicating whether the maximum cut depth can be calculated
Public propertyMemberSpanEnd Gets the end of the member span the haunch is attached to
Public propertyMemberSpanInfo Gets the info of the member span the haunch is attached to
Public propertyOffset1 Gets the value of offset 1 (in [mm])
Public propertyOffset2 Gets the value of offset 2 (in [mm])
Public propertyPortalFrameRafterPosition Gets the position of the rafter the haunch is attached to
Public propertySectionDerivation Gets the derivation of the haunch section
Public propertySteel Gets the steel
Top
See Also
Was this helpful?
The feedback you give here is not visible to other users. We use your comments to improve the content.
Previous
Next